Your Water Cooler Speciality Store.
Customer Service: 1-877-671-4236
Over 60 years of professional experience
 
 
0 item(s) in cart / Total: $0
Home > Instructional Help Center > Single Filtration Kit Installation Guide
 

Single Filtration Kit Installation Guide

Follow the steps below to set up and connect your water filter and install kit.
Insert the metal mounting bracket into the center of the condenser located on the back of the unit.
Anchor the mounting bracket to the condenser with a screw (Note: place screw on either the far right or left side of the mounting bracket).

Anchor the filter clip to the mounting bracket with a screw.
Shut off water supply and install angle stop valve into your water source.
Push one end of the John Guest tubing into the quick connect fitting of the angle stop valve until it bottoms.
[Optional] Use the tube anchoring clips to conceal the John Guest tubing against the wall, floor, ceilling, ect.
Remove the white saftey plugs from both ends of the filter by pressing down on the quick connect fitting and pulling up on the plug.
[Important] Flow Direction: Install the John Guest tubing from the angle stop valve into the IN (capped end) of the filter.
Flush the filter for 10 minutes before use by placing the OUT end of the John Guest tubing into a sink, turn on your water supply and open the angle stop valve allowing water to flow through the filter.
Once flushed, push the body of the filter into the filter clip until it snaps into place.
Install tubing from the OUT (non-capped end) of the filter into the quick connect fitting on the units float assembly.
 
 
My Account Customer Service Company Information
Sign In Online Help Center About WaterCoolersUSA.com
View Cart Standard Return Policy Terms and Conditions
  Shipping Information
Copyright 2015 Pittsburgh Water Cooler Service Inc. All Rights Reserved